XJ-6 L6-3.6L (1989)
^
Install and tighten the adaptor bolt.
^
Install and tighten the test point (05) and seal washer to the right angled adaptor.
Test Note 10 Thru 12
Test Note 10:
After VIN 528301, XJ6 3.6 vehicles incorporate a modified valve block. For identification, the valve block has been dated coded, (Fig. 4). An
identification number above 2002 (15 AW) indicates a modified valve block.
Test Note 11:
To remove the ride levelling strut adaptor, use the following procedure:
^
Raise vehicle on lift (rear wheels must be suspended).
^
Remove the pipe and gauge assembly.
^
Remove ride levelling strut adaptor.
^
Re-install the bleed nipple.
^
Perform strut bleeding procedure (refer to Technical Service Bulletin section 64, number 2).
Test Note 12:
It is sometimes possible to hear the relief valve in the valve block operating when the sensor link arm is raised or lowered. This is a normal condition.
