XJ-6 L6-3.6L (1989)
7.
Connect rubber hose (see Fig.2, C) to the electric motor assembly (see Fig.2, B).
8.
Connect the rubber elbow hose (Fig.2, D) to the ventilator tray assembly.
9.
Install the sensor assembly (see Fig.2, E).
10.
Using contact cement, position and adhere the blanking plate over the outer ventilator tray outlet (see Fig.2, F).
11.
Position ventilator tray in footwell area (do not install at this point).
12.
Remove glove box access panel.
13.
Disconnect the existing sensor harness connector multiplug "AC7" and connect the new link harness (Fig.2, G) between "AC7" and the new sensor
(see Fig.2, E).
