XJ-6 L6-3.6L (1989)
Crankshaft Position Sensor: Fundamentals and Basics
Crankshaft sensor output should be:
2.4 V (AC) @ idle (approximate)
5.0 V (AC) @ 3000 rpm (approximate)
If the vehicle does not start you should expect a reading of approximately .8 - 1.0 V (AC) while cranking.
AC Voltage is read by connecting a DVOM to both pins of the sensor (via backprobing) on the AC voltage setting. Readings can also be taken at the
engine control module by backprobing the appropriate pins (see wiring diagram).