XJ-6 L6-3.6L (1989)
10.
Fit Jaguar special tool JD131, or equivalent, to throttle stop plate and align pointer with "I" mark, as shown.
11.
Loosen full throttle stop screw lock nut.
Throttle Valve Adjust
12.
Fully open throttle and adjust full throttle stop screw to align pointer with "A" for automatic transmission cars or "M" for manual transmission
cars.
13.
Release throttle and tighten full throttle stop screw.
14.
Remove special tool.
15.
Check kick down cable adjustment. Adjust cable adjusting nut to obtain proper gap between outer cable housing and inner cable crimp slip ring,
as measured with feeler gauge. Measured gap should be:
0.030 in (0.76 mm)
16.
Tighten lock nut.
17.
Refit cable dust cover.
18.
Checking and adjustment throttle potentiometer requires use of Jaguar Diagnostic System.
19.
Refit and align elbow and hose assembly to throttle housing and tighten clamps.
20.
Connect elbow to air flow meter and tighten clamp.
21.
Fit elbow to rubber mounting and tighten nut.
22.
Refit breather hose and supplementary air valve hose to elbow.
23.
Check base idle speed.
