XJ-6 L6-3.6L (1989)
Ignition Switch Lock Cylinder: Service and Repair
RENEW
- Open the door.
- Centralize the road wheels and remove the ignition key.
- Remove the pad from the centre of the road wheel.
- Slacken the nut securing the wheel to the shaft, do not fully remove.
- Pull steering wheel to release from the shaft, remove the securing nut and steering wheel.
- Remove the split collars from the steering column.
- Remove the screws securing the dash liner and release the liner securing clip.
- Remove the dash liner.
- Disconnect the steering column switch assembly block connector.
- Remove the nut and bolt securing the universal joint to the upper column.
- Remove the bolts securing the steering column lower bearing to the bracket.
- Remove the nuts securing the steering column to the upper mounting, remove the safety bracket and carefully lower the column.
- Note and collect the steering column spacing washers and remove the upper column from the vehicle.