XJ-6 L6-3.6L (1989)
15.
When the bushing is in position, quickly press the bushing in.
Note:
The adhesive application and pressing operations must be completed in 4 - 6 minutes.
16.
Wipe off all excess adhesive from the subframe and the bushing. Remove the masking tape.
17.
After the bushing has been inserted in the subframe, check for any clearance between the bushing flange and the subframe, (Illustration 4). If a gap
is present, it must not exceed 1.5 mm.
18.
Repeat the operation for the other bushing.
Note:
The subframe assembly should not be reinstalled until at least 4 hours have elapsed, to allow the adhesive to "cure".
PARTS INFORMATION
WARRANTY INFORMATION:
