XJ-6 L6-3.6L (1989)
Wheel Hub: Technical Service Bulletins
Front Hub End Float - New Specification & Adjustment
Front Hub - End Float New Specification -Adjustment Procedures
MODEL
All
DATE
5/92
57-15
ISSUE:
Front hub end float specification change.
ACTION:
Front hub end float should be adjusted using the following procedure:
NOTE:
Before performing this operation, place an absorbent cloth around the brake fluid reservoir cap.
^
Remove the front wheels.
^
Gently pry the brake pads away from the discs. Make sure that the disc can rotate freely without coming in contact with the pads.
^
Remove the hub grease cap, (Fig. 1 A).
^
Install a dial test indicator to the hub, (Fig. 2).
^
Grasp the hub firmly. Push the hub in and then pull it out. Note the reading on the dial.
