Service and Repair for Dashboard and Interior Moulding on XJ-6 (1991) L6-40L
Dashboard / Instrument Panel: Service and Repair
Remove:
- Dash liner drivers side. See: Trim Panel/Service and Repair
- Dash liner passenger side.
- Fascia closing panel drivers side.
- Fascia closing panel passengers side.
- Fascia centre veneer panel.
- Steering the wheel.
- Instrument housing.
- Remove centre console upper securing screw carefully manoeuvre the console rearwards for access to the fascia tie bar securing nuts. Ensure that the
rear heater outlet and control are not disturbed.
- Remove the fascia tie bar securing nuts and move the tie bar away from the fascia.
- Remove passenger footwell duct and relay panel from the glove box and position the panel in the footwell.
- Remove bolts securing the fascia outer body bracket to the fascia, remove the fascia centre securing bolt, access to this bolt is through the instrument
housing aperture.
- Remove the fascia outer lower securing bolts, disconnect the trip computer and lighting module block connectors, remove the screws securing the trip
computer / lighting module and remove the module from the fascia.
- Manoeuvre the fascia rearwards for access, disconnect the solar sensor block connector, note the position and disconnect the vacuum hoses,
disconnect the glove box lamp block connector and remove the fascia assembly.
- Remove glovebox lid.
- Remove glovebox lid striker.
- Remove the glovebox inner and outer securing screws, manoeuvre the glovebox from the fascia.
- Remove glove box frame.
- Remove the frame upper spacing washers.
- Disconnect and pull the centre vacuum hose through the grommet.
- Remove the screws securing the centre vent and remove the vent assembly.
- Remove the screws securing the instrument housing locating bracket and remove the bracket.
- Remove the solar sensor panel from its mounting position.
- Remove the screws securing the defrost outlet duct and remove the ducts.
- Remove the screws securing the defrost vent, disconnect the vacuum hose and remove the vent assembly.
- Carefully displace the solar sensor harness from its position, cut the ratchet strap securing the harness and vacuum hoses to the fascia.
- Remove the grommet from the fascia and the harness/vacuum hose assembly.
- Remove the outer ventilator assemblies and the spire nuts from the fascia.
- Discard the fascia.
- Fining is the reversal of this procedure.
