XJ-6 L6-4.0L (1991)
7.
Remove the height adjuster adhesive pad (Illustration 2) and replace with a new one (P/N BEC 21458).
8.
Reinstall the height adjuster trim after removing the backing paper from the adhesive pad.
9.
Install two pieces of anti-squeak tape (P/N JLM 11558) as shown in Illustration 3.
10.
Slide the upper trim pad up under its retaining clips, fit and smooth out the door opening edge trim.
11.
Fit the upper seat belt anchor plate and install the original retaining nut. Make sure the seat belt anchor plate is free to rotate.
12.
Snap on the retaining nut cover and seat belt bezel.
13.
Repeat procedure for the other front seat belt.
14.
Connect the ground cable of the battery, program preset radio stations, and reset the clock.
WARRANTY INFORMATION:
NOTE:
Repairs may be made only on a customer complaint basis
PARTS INFORMATION:
DESCRIPTION
PART NUMBER
QTY/
VEHICLE
Foam washer
KZS 100002
2
Anti-squeak tape
JLM 11550
4
Adhesive pad
BEC 21485
2
