XJ-6 L6-4.0L (1991)
^
Support the tool/pump assembly in the "fork" of tool JD 119, (fig. 11).
FIG. 12
^
Use a 22 mm wrench to prevent the bolt from turning, (fig. 12). Use a 28 mm wrench to turn the center section of tool 18G 1445 in a clockwise
direction to press the drive dog on to the shaft.
FIG. 13
^
Continue pressing the drive dog (fig. 13 A) on to the shaft until the shaft (fig. 13 B) is approx. 1/8 in. (3.175 mm) clear of it. Use a depth gauge to
check the dimension and adjust if necessary.
CAUTION: Refer only to the previously described removal and replacement procedures to prevent power steering pump damage.
