XJ-6 L6-4.0L (1991)
^
Remove tool JD 184, the pinion cover plate and the shims, (Fig. 5).
^
Install tool JD 184 to the pinion, (Fig. 2).
^
Remove the pinion from the housing by gently pulling, (Fig. 6). The pinion will rotate 90~ counter clockwise. Remove JD 184.
^
Remove thrust washer assembly from the top of the pinion. Clean the thrust washer and save for re-assembly.
^
Remove and discard the pinion quad seal from the lower pinion housing. Clean and check the pinion housing for damage.
NOTE:
Service Tool JD 185 is a three piece tool comprised of the following:
-
Tapered mandrel