XJ-6 L6-4.2L (1983)
SERVO LOAD EXCESSIVE
-
Move bolt (2) 1/16" away from bellcrank center.
-
Then repeat basic adjustment procedure, leaving nut (2) in new position.
SERVO LOAD WAS OKAY
-
Pull down servo lever (7) to make sure heating flaps are closed.
-
If flaps are not fully closed, move bolt (2) 1/16" toward bellcrank center.
-
Then repeat basic adjustment procedure leaving bolt (2) in new position.
TEMPERATURE DIFFERENTIAL ADJUSTMENT
-
Select "DEFROST".
-
Move temperature differential thumbwheel fully to he right.
-
Turn on ignition. Servo will move to full hot limit.
-
Turn off ignition.
