XJ-6 L6-4.2L (1983)
Output Shaft: Service and Repair
BORG WARNER 66
OUTPUT SHAFT AND RING GEAR
Overhaul
Dismantling
Fig. 56
191. Remove and discard the sealing rings from the output shaft (Fig. 56).
192. Remove the snap-ring retaining the Output shaft; withdraw the shaft (Fig. 56).
Inspection
193. Check the drillings in the output shaft for obstruction; clear with compressed air Only.
194. Check the splines, sealing ring grooves and gear teeth for burrs or signs of damage; renew if damaged. Minor burrs may, however, be removed with
a very fine abrasive.
195. Check bush for scores or evidence of metal transfer. Should damage be evident, Output shaft must be renewed.
Reassembling
Reverse operations 191 and 192.
CAUTION: Ensure that the gaps in the sealing rings are staggered.