XJ-6 L6-4.2L (1983)
Rear Door Window Motor: Service and Repair
Remove and Refit
- Remove the door casing and arm-rest. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair
- Disconnect the battery.
- Disconnect the cables from the motor at the plug and socket connection (1, Fig. 33).
- Remove the four pan-headed setscrews and detach the regulator mechanism from the door panel (2, Fig. 33).
- Adjust the position of the door until the regulator arm can be removed from the channel. Withdraw the regulator through the aperture in the door.
- If it is necessary, remove the glass in order to withdraw the regulator.
- Withdraw the three setscrews and washers and detach the motor from the regulator. The motor is sealed during manufacture. Faulty units must be
replaced, no service repair being possible.
- Refitting is a reversal of the above procedure.
