jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Overview|Page 3623 > < Diagram Information and Instructions|Page 3620
Page 1
background image

Hydraulic Control Assembly - Antilock Brakes: Description and Operation
Overview

CONTROL MODULE COMPONENTS

The ABS CM is located beneath the modulator valve block and is secured by two screws. The CM houses the solenoids which operate the inlet
and outlet valves of the modulator valve block. When fitted, the valve stems locate in the CM mounted solenoids. The only electrical connection
between the CM and the modulator valve block is to the hydraulic pump.

FUNCTIONS OF CM

-

Providing control signals for the operation of ABS control solenoid valves

-

Calculating wheel speed from voltage signals transmitted by the wheel speed sensors

-

Monitoring of all electrical components

-

On Board Diagnostics (OBD): storage of possible failures in a non-volatile memory.

Signals From The Wheel Speed Sensors - are independently processed by the ABS CM, calculating numerical values which correspond directly
to the wheel speed. These values are converted into control signals for pressure modulation during ABS control.

The ABS Is Continuously Monitored-  while the ignition is on, for possible faults and interruptions. If a fault is detected, the module de-activates
the ABS and indicates this by lighting the ABS warning lamp. In a fault condition, conventional braking is unaffected. The module stores fault
codes in a non-volatile memory which can be read via the OBD link.

PURPOSE

The hydraulic pump (1) is a reciprocating two-circuit pump in which one brake circuit is assigned to each pump circuit. The pump supplies
adequate pressure and volume supply to the brake circuits under anti-lock braking conditions. The pump is driven by an electric motor (2). The
pump housing incorporates two low pressure accumulators and damping chambers for each brake circuit.

MODULATOR VALVE BLOCK

A modulator valve block (3) incorporates the ABS CM or ABS/TC CM (4). Vehicles with traction control are fitted with a throttle position
actuator (5), which is an electrical device controlled by the ABS/TC CM.

Overview|Page 3623 > < Diagram Information and Instructions|Page 3620