XJ-6 (X300) L6-4.0L (AJ16) (1996)
-
Release and remove the rotary switch protection cover (1 Fig.1) securing bolts; displace and remove the switch cover.
-
Disconnect the transmission multi-pin socket (2 Fig.1}.
-
Reposition the harness clear of the transmission unit.
-
Release and remove the rotary switch securing nuts.
-
Displace and remove the switch assembly.
-
Displace and remove the 'P' clips from the harness.
-
Fit and align the 'P' clips to the new harness / switch assembly.
-
Displace the rubber sealing plug (3 Fig.1) from the rotary switch.
-
Ensure the shift lever is in 'N'.
-
Fit and fully seat a new rotary switch to the transmission unit.
-
Fit but do not fully tighten the rotary switch securing nuts.
-
Fit and align Service Tool JD161 (Fig. 1) to the rotary switch to align the switch rotor to the switch body.
-
Finally torque tighten the rotary switch securing nuts.
-
Displace and remove Service Tool JD161.
-
Reposition and fit the rubber sealing plug to the switch.
-
Reconnect the transmission unit multi-pin plug.
-
Reposition the harness and feed the multi-pin plugs and grommet through the tunnel aperture.