XJ-6 (X300) L6-4.0L (AJ16) (1996)
/l6-4.0l_(aj16)/Page-1335002.png)
^
Fit and align tools to rear spring and tighten tool centre bolts evenly to compress spring.
^
Ensure tool jaws are sitting correctly on springs.
^
Undo and remove nut securing damper assembly to wishbone shaft.
^
Remove strut lower shaft.
^
Undo and remove nuts securing damper assembly mounting plate to body.
^
Secure mounting plate to road spring using retaining straps JO 199-1 (2 Fig. 1).
^
Using a suitable jack (3 Fig.1) and spacer (4 Fig. 1), compress damper up through the wishbone and insert a suitable bolt (5 Fig. 1) through coils
of spring and damper lower bush.
^
Lower jack and remove spring/damper assembly (6 Fig. 1) from vehicle.
^
Compress damper to remove bolt from spring coils.
^
Remove retaining straps JD 199-1 from mounting/bracket spring.
^
Position spring/compressor assembly on a bench, mark location of compressor tools on spring.
^
Undo spring compressors evenly and remove from springs.
^
Refit in reverse order to removal procedures
