XJ-6 (X300) L6-4.0L (AJ16) (1996)
Transmission Speed Sensor: Service and Repair
TRANSMISSION SPEED SENSOR, RENEW
-
Raise the hood and fit a fender cover.
-
Raise the vehicle on a ramp.
-
Drain the transmission lubrication system.
-
Remove the fluid pan.
-
Displace the transmission speed sensor harness from the valve body rear securing clip.
-
Release and remove the speed sensor and connector retaining clip from the valve body.
-
Displace the speed sensor and connector from the transmission main casing.
-
Disconnect and remove the speed sensor from the harness connector.
-
Clean the speed sensor, retaining clip and mating surface.
-
Connect the new speed sensor to the harness connector.
-
Fully seat the speed sensor into the transmission unit main casing.
-
Fit the speed sensor and connector retaining clip to the valve body, engaging the tangs onto the connector.
-
Fit and tighten the speed sensor and connector retaining clip securing screws.
-
Reposition and fully seat the speed sensor harness into the valve body rear; secure the clip.
-
Refit the fluid pan.
-
Lower the vehicle on the ramp.
-
Refill the transmission unit with fluid.
-
Remove the fender cover and lower the hood.