XJ-6L (X300) L6-4.0L (AJ16) (1997)
Front Door Exterior Handle: Service and Repair
Door Handle Operating Rod
Fig. 1
-
Disconnect vehicle battery ground lead.
-
Remove the door trim veneer, door upper trim pad, door lower trim pad.
-
Disengage the handle operating rod retaining clip and free the rod from the operating pivot.
-
Allow the latch lever to contact the release mechanism, reposition the operating rod and replace the retaining clip.
-
Check that the setting is correct by operating the door mechanism.
Refit in the reverse order of the removal procedure.
NOTE: Fig.1 shows front door components only.