XJ-8 Sedan (X308) V8-4.0L (AJ27) (1999)
2. Fit and fully seat veneer panel to instrument surround.
3. Connect ground cable to battery terminal and fit battery cover. See: Starting and Charging/Battery/Service and Repair
4. Turn ignition key to position II.
5. Return steering column to original position.
6. Turn ignition key to position 'O'.
Rear Quarter Upper Trim Pad
REAR QUARTER UPPER TRIM PAD
Removal
1. Remove draught welt from adjacent section of door aperture.
2. Disconnect and remove the rear courtesy/reading light.
3. Remove combined grab handle and coat hanger hook.
4. Carefully ease trim pad fir tree fasteners from BIW locations.
5. Remove trim pad from vehicle and remove and discard fir tree fasteners.
Installation
1. Fit new fir tree fasteners to trim pad.
2. Position trim pad at rear quarter and press and fully seat fir tree fasteners in BIW locations.
3. Fit combined grab handle and coat hanger hook.
4. Connect and fit rear courtesy/reading light.
5. Fit draught welt to adjacent section of door aperture flange.
Rear Door Glass Lift Switch/Ashtray Veneer Panels
Removal
1. Remove door casing veneer panel. See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair
2. Remove door casing. See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair
3. Remove door armrest and remove switch/ashtray assembly from armrest. See: Arm Rest/Service and Repair