XJ-8 Sedan (X308) V8-4.0L (AJ27) (1999)
Seals and Gaskets: Service and Repair
Oil Pump Front Seal
Front Seal - Oil Pump
Removal
1. Remove the transmission unit.
2. Remove the torque converter from the transmission unit.
3. Remove the front pump seal.
Remove and discard the seal retaining snap-ring.
Using a 'Snap-on' oil seal puller, remove and discard the seal.
4. Clean the seal housing.
Installation
1. Installation is the reverse of the removal procedure.
2. Use tool 307-357 to install the seal.
Lubricate the seal prior to fitting.