XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
1. Slacken hook adjustment nuts until weight of engine is released.
2. Remove hooks from engine front lifting eyes.
3. Remove special tool 303-021 from fender channel.
11. Install crossbeam to engine Hydramount bolts.
-
Install bolt securing Hydramount to crossbeam and tighten to 34-46 Nm.
-
Repeat procedure to install crossbeam opposite side bolt.
12. Tighten rear mounting bolt and nut to 131-185 Nm.
-
Repeat procedure to tighten opposite side rear mounting bolt and nut.
13. Connect steering rack transducer harness front connector.
-
Connect steering harness connector.
-
Install harness connector on body retaining clip.
14. Slacken adjuster nut and remove camber tie down tool 204-114 from suspension.
-
Repeat procedure to remove tie down tool from opposite side.