XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
3. Remove brake pads from caliper.
1. Withdraw pins from caliper.
2. Remove anti-rattle spring.
3. Remove brake pads.
4. CAUTION: Only remove the bolts securing the caliper anchor bracket to the hub carrier. Refer to caution above for more information.
CAUTION: Do not allow the caliper to hang on the hydraulic hose, as this will damage the hose.
Remove caliper from hub carrier.
^
Remove bolts.
^
Remove and tie caliper aside.
5. Make sure that wheel bearing end-float is within specification.
6. NOTE: Measurement of the brake disc run-out, must be carried-out with the disc and hub access holes aligned.