XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
/v8-4.0l_(aj27)/Page-851004.png)
2. Install fluid reservoir to master cylinder.
^
Remove plugs from reservoir
^
Install reservoir, making sure reservoir is fully seated.
^
Install locating pin.
3. Install master cylinder to brake booster.
^
Install seal.
^
Install master cylinder, make sure master cylinder rod locates brake booster rod.
4. Install and tighten nuts to 21 - 29 Nm.
5. Install pedal housing, brake booster and master cylinder assembly.
6. Install engine compartment rear cover.
7. Connect battery ground cable.
8. Bleed brake system.
9. Remove paint-work protection covers and close engine compartment.
