XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
/v8-4.0l_(aj27)/Page-409002.png)
^
Release deflector from rear vertical duct.
11. Remove screws or scrivets securing undertray to bumper cover. Discard scrivets.
12. Remove and discard tiestrap securing undertray to body brace.
13. At each side of vehicle, remove and discard scrivet securing undertray to wheelarch liner.
14. Remove undertray from vehicle.
15. Position camber tie down special tool 204-114 on suspension.
^
Fully slacken tool adjuster nut.
^
Position tool in road spring and pass upper dowel through slot in suspension turret.
16. Lower front of vehicle.
17. Rotate stem of special tool 204-114 to locate dowel in suspension turret slot.
18. Lower front of vehicle.
19. WARNING:
WHEN TIGHTENING TOOL NUT, USE LOWER DOWEL AS A GUIDE TO ENSURE THAT THE TOOL STEM DOES NOT ROTATE
