XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
Steering Gear: Service and Repair
Steering Gear
Removal
1. Center the steering wheel.
Lock in position, remove the ignition key.
2. Remove both be-rod ends.
3. Remove both be-rod end lock nuts.
4. Remove the air deflector.
5. Disconnect the power steering control valve actuator electrical connector.
6. Detach the lower steering column.
Remove the steering gear shaft pinch bolt.
7. CAUTION: Cap the power steering lines to prevent loss of fluid and prevent dirt ingress.
CAUTION: If power steering fluid comes into contact with the paintwork, the affected area must be immediately washed down with cold water.
NOTE: Drain the fluid into a suitable container.
Disconnect the power steering supply and return lines.
Remove and discard the O-ring seals.