XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
/v8-4.0l_(aj27)/Page-995025.png)
5. Install stabilizer bar to crossbeam.
^
Ensure bushes are correctly positioned on stabilizer bar.
^
Install support brackets over bushes.
^
Position stabilizer bar on crossbeam.
^
Install and tighten bolts to 30-40 Nm.
^
Repeat procedure at opposite end of stabilizer bar.
6. Tighten link arm to stabilizer bar securing nut to 60-80 Nm.
^
Repeat procedure at opposite end of stabilizer bar.
7. Install steering rack on crossbeam.
^
Ensure that bushes are correctly positioned on steering rack.
^
Position steering rack on crossbeam.
^
Position support brackets over bushes.
^
Install mounting bracket bolts and tighten to 40-54 Nm.
8. Install tie rods on steering arms.
^
Position and fully seat tie rod ball joint taper pin on steering arm.
^
Install tie rod ball joint nut and tighten to 71-85 Nm.
^
Repeat procedure to install opposite side tie rod ball joint.
9. Install harness on suspension turret.
^
Noting positions marked during removal, tape new securing clips to steering harness.
^
Install securing clips/harness on LH turret.
10. With assistance position crossbeam/suspension assembly on jack with protective wood under.
11. Traverse assembly into position below vehicle.
12. Ensure steering harness connector is positioned to avoid damage during crossbeam lift .
