XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
10. Install bush in housing.
^
Position a steel plate over the bush, ensuring the plate is large enough to cover the rubber flange.
^
Operate the press to install the bush.
11. Ensure bush is fully seated in subframe.
^
The clearance between the bush flange and subframe must not exceed 1.5 mm.
12. Ensure bush is aligned correctly in subframe as detailed in Step 8 or 9 as appropriate.
13. Wipe off all excess adhesive from subframe and bush, and remove masking tape.
14. NOTE:
Allow adhesive at least 30 minutes to cure, before installing subframe on vehicle.
Install suspension subframe on vehicle.