XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
31. Remove bearing cup from hub carrier.
^
Position hub carrier on a piece of wood.
^
Position a long tapered drift in housing bore recess.
^
Remove bearing cup.
32. Repeat procedure to remove opposite end bearing cup and discard both cups.
33. Remove hub carrier from vise.
34. Thoroughly clean all components.
Installation
1. Using a hydraulic press, install new bearing cups in hub carrier.
1. Position hub carrier on press-bed.
2. Using special tool 100-013 and adapter 204-120, align bearing cup to hub carrier.
^
Align assembly to ram, and operate press to fully seat bearing cup.
^
Repeat procedure to fit other bearing cup.
2. Secure hub carrier in a vise.
3. Install pivot pin sleeve in hub carrier.
4. Pack new pivot bearings with Shell Retinax 'A' grease.