XJ-8L Sedan (X308) V8-4.0L (AJ27) (2001)
/v8-4.0l_(aj27)/Page-749006.png)
14. Release ball joint from vertical link.
1. Install special tool 211-098 on tie rod outer ball joint.
2. Tighten tool bolt to release taper pin from vertical link.
15. Remove special tool from ball joint and position tie rod for access.
16. Remove nut securing upper wishbone ball joint to vertical link.
17. CAUTION: Do not use special tool 21 1-098 in the following procedure as this will damage the ball joint gaiter.
Release upper wishbone ball joint from vertical link/hub assembly.
1. Install special tool 204-192 on ball joint.
