XJ-S V12-5.3L (1982)
4.
Remove pivot pin and cover.
5.
Unscrew ratchet nut from adjusting screw.
6.
Clean threads on adjusting screw and nut. Be sure the nut turns freely.
7.
Clean any old, hardened grease from the unit.
8.
Apply new grease or antiseize to threads and under ratchet spring piece.
9.
Reverse steps to reassemble.
Handbrake Pads
REFIT
1.
If new pads are fitted or caliper has been overhauled, adjust caliper by holding one carrier and rotating the other, until a dimension of
approximately 0.75 in (19 mm) between pad surfaces, is reached. This will assist in refitting. Be sure of pad orientation.
2.
Place caliper into rear suspension unit. Long carrier arm should be on inside of brake disc.
3.
Slide caliper up around brake disc and position into mounting bracket.
4.
Check mounting holes with a mirror for alignment.
5.
Fit retractor and recheck alignment with mirror.
6.
Fit tab washer plate and threaded mounting pins. Be sure the pins engage the caliper holes. (It is easy to miss one!) It is recommended that the
short carrier pin is engaged first.
7.
Tighten mounting pins and bend lock tabs.
8.
Operate caliper lever(s) several times to adjust pad clearance.
9.
Reconnect return springs and cable.
