jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 6435 > < Diagram Information and Instructions|Page 6433
Page 1
background image

Temperature Sensor (Gauge): Service and Repair

COOLANT TEMPERATURE TRANSMITTER 

5.3L V12

3.6L L6

 
RENEW

 

Open the bonnet.
Disconnect the battery earth lead.

WARNING: DO NOT REMOVE THE CAP AT THE REMOTE HEADER TANK UNLESS THE ENGINE IS COLD. 

Remove the radiator pressure cap to depressurise the a system.
Disconnect the transmitter feed wire.
Unscrew and remove the transmitter.  Remove and discard the seal/washer.

Fit a new seal/washer to the replacement transmitter.
Fit and tighten the transmitter.
Reconnect the transmitter feed wire.
Check/top up the coolant. Refit the pressure cap.

NOTE: Always top-up with recommended strength of antifreeze, NEVER WITH WATER ONLY.

Reconnect the battery earth lead.
Close the bonnet.

DATA 

TORQUE FIGURES

Transmitter to engine - 49-54 Nm

SPANNER SIZES

22 mm

Diagram Information and Instructions|Page 6435 > < Diagram Information and Instructions|Page 6433