XJ-S V12-5.3L (1982)
Power Steering Pump: Service and Repair
Disassemble
Fig. 14 High Pressure Outlet Union Removal
Fig. 15 Magnet, O-ring & Retaining Ring Disassembly
Fig. 16 Pump Assembly Removal
1.
Remove rear mounting plate, then the pump pulley.
2.
Noting position and relative sizes of spacers, remove front mounting plate.
3.
Thoroughly clean exterior of pump.
4.
Remove high pressure outlet union and mounting plate studs (1), Fig. 14.
5.
Tilt pump to one side to remove flow control valve and spring (2).
6.
Place spindle body in a vise and carefully tap pump casing from body (3).
7.
Remove three O-rings from ports in pump body. Remove magnet on pump body flange (1). Fig. 15.
8.
Insert pin punch into pump body and push retaining ring (2) free from its groove. Remove from retaining ring from body. Fig. 15.