XJ-S Convertible (XJ27) L6-4.0L (1996)
Rotary Selector Switch: Service and Repair
Rotary Switch
TRANSMISSION ROTARY SWITCH, RENEW
-
Check the shift cable adjustment.
-
Switch the ignition ON, apply the footbrake and move the shift lever to 'N'.
-
Switch the ignition OFF and disconnect the battery.
-
Open the armrest lid.
-
Release and remove the ashtray securing screws.
-
Displace the ashtray assembly for access.
-
Disconnect the cigar lighter/illumination harness connectors.
-
Place the ashtray assembly aside.
-
Displace and remove the console veneer panel rear finisher.
-
Carefully displace the Performance Mode switch from the gear surround finisher.
-
Disconnect the Performance Mode switch from the harness multi-pin plug.
-
Displace and remove the Performance Mode switch surround finisher.
-
Displace and remove the shift lever surround finisher.
-
Release and remove the veneer panel wing nuts.
-
Displace and remove the console finisher veneer panel.
-
Cut and remove the rotary switch harness securing straps.
-
Disconnect the rotary switch harness multi-pin plugs. Reposition the tunnel carpet for access to the harness grommet.
-
Displace and reposition the grommet down through the tunnel.
-
Feed the harness through the tunnel to the underside of the vehicle.
-
Raise the vehicle on a ramp.
-
From beneath the vehicle, release and remove the rotary switch harness to transmission 'P, clip securing nut; displace and reposition the 'P' clip
from the stud.
-
Release and remove the rotary switch harness to transmission 'P' clip securing screw.