XJ-S Convertible (XJ27) L6-4.0L (1996)
Fuel Supply Line: Service and Repair
Internal Tank Hoses
-
Remove the fuel tank assembly.
NOTE: Operations within fuel tank assembly must only be performed with use of screwdriver JD 175.
-
Release clip and disconnect breather hose from the evaporative loss flange.
-
Using tool JD 174, displace and remove the evaporative loss flange retaining ring.
-
Reposition the flange for access to the fuel pump harness multi-plug, disconnect the multi-plug.
-
Using screwdriver JD 175 release the internal feed and return hose securing clips and disconnect hoses from the pump assembly.
-
Using a twisting action displace and remove the pump assembly.
-
Slacken the feed hose to the internal stub pipe securing clip (1 Fig. 1), displace clip and remove the hose.
-
Position and secure new feed hose to the internal stub pipe.
-
Fit and fully seat the fuel pump assembly to the mounting, engaging the master lug.
-
Reposition hoses to the pump and tighten securing clips.
-
Fit and seat new evaporative flange seal.
-
Connect evaporative loss flange to pump multi-plug.
-
Seat evaporative loss flange to seal.
-
Using tool JD 174 secure flange with retaining ring.
-
Connect and secure breather hose to flange stub pipe.
-
Reposition the tank assembly to the vehicle.
-
Refit the tank by reversing the removal operations.
-
Ensure new O-rings and seals are fitted.
-
Ensure all electrical connections are clean and secure.
-
Check all flange, hose and pipe connections for security and signs of leakage.