XJ-S Convertible (XJ27) V12-6.0L (1994)
/v12-6.0l/Page-763005.png)
in two places to lock the shaft nut. Remove the assembly from the vice.
Fig.1
Before fitting the output shaft assembly, ensure that the four disc flange bolts (4, Fig.1) are in position, and that a new O-ring (3, Fig.1) is fitted. Lightly
oil the splines and outside of the bearing with final drive oil, and insert the output shaft assembly. Fit and torque tighten the securing bolts.
Refit the brake caliper and disc.
Check/adjust the camber angle of the rear wheels.
SERVICE TOOLS
18G 47 Hand press
18G 681 Torque screwdriver
SL 15 B Output shaft nut wrench
SL 47-3/1 Bearing remover/replacer
SL 47-3/2 Bearing remover/replacer
TORQUE FIGURES
Output shaft bearing housing to unit 81.5 - 93.5 Nm
OILS / SEALANTS / LUBRICANTS
Differential oil Shell Spirax Super 90
