XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
Front Bumper Reinforcement: Service and Repair
Front Bumper (76.22.08)
Removal
WARNING: ENSURE THAT ALL PERSONNEL AND EQUIPMENT ARE CLEAR OF AREA BEFORE OPERATING RAMP.
1. Position vehicle on 4-post ramp.
2. Remove battery cover and disconnect ground cable from battery terminal.
3. Remove radiator surround and grill.
4. Raise ramp to working height.
5. Using wheel-free lifts, remove front wheels.
6. Remove wheelarch liners for access.
7. Remove undertray.
8. At each side of vehicle:
-
Disconnect fog lamp, direction indicator and sidemarker lamp (where fitted) harness multiplugs.
-
If headlamp powerwash is fitted, remove and discard plastic clip from hose and disconnect hose at RH side of bumper.
9. Slacken and remove bolts securing bumper assembly to mounting struts.
10. Lower 4-post ramp.
11. Carefully withdraw bumper casing and beam assembly forward to clear guide blocks and remove assembly from vehicle.
12. Remove number plate and plinth from bumper cover.
13. Slacken and remove three bolts securing each fog lamp to bumper cover and remove both lamps from cover.