XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
18. WARNING:
WHEN TIGHTENING TOOL NUT, USE LOWER DOWEL AS A GUIDE TO ENSURE THAT THE TOOL STEM DOES NOT ROTATE
AND DISTURB POSITION OF DOWEL IN SUSPENSION TURRET.
Tighten nut of special tool 204-114 to full extent, to achieve suspension mid-laden position.
19. Raise front of vehicle and support on stands.
20. Remove front road wheels.
21. Remove crossbeam to engine Hydramount bolts.
^
Remove bolt securing crossbeam to Hydramount.
^
Fully withdraw bolt into crossbeam insert.
^
Repeat procedure to remove and withdraw bolt on opposite side
22. Remove lower nut and bolt from front shock absorber.
^
Repeat procedure to remove bolt from opposite side shock absorber.
23. Slacken but do not remove crossbeam rear bolt and nuts.
^
Slacken crossbeam LH rear mounting bolt and nut.
^
Repeat procedure to slacken crossbeam RH rear mounting nut.
24. Release lower steering column from pinion shaft.
1. Remove lower steering column nut and bolt.
^
Move column upwards to release it from pinion shaft.