XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
14. With assistance position crossbeam/suspension assembly on jack with protective wood under.
15. Traverse assembly into position below vehicle.
16. Ensure steering harness connector is positioned to avoid damage during crossbeam lift.
17. NOTE: It may be necessary to use a hammer and drift to finally align new mounting with body location.
Carefully raise crossbeam assembly into position.
-
Ensure that dowels of both crossbeam mountings seat correctly in body locations.
18. Ensure that both engine hydramounts seat correctly in crossbeam locations.
19. Install crossbeam rear mountings.
-
Align rear mounting rubber with body location.
-
Install rear mounting securing bolt and nut and tighten nut to 131-185 Nm.
-
Repeat procedure to install opposite side rear mounting securing bolt and nut.
20. From engine compartment, install but do not tighten crossbeam front RH bolts.