Front Axle Crossmember Front Bushing Replacement Guide
13. At each side of vehicle, remove and discard scrivet securing undertray to wheelarch liner.
14. Remove undertray from vehicle.
15. Position camber tie down special tool 204-114 on suspension.
-
Fully slacken tool adjuster nut.
-
Position tool in center of road spring and pass upper dowel through slot in suspension turret.
16. Lower front of vehicle.
17. WARNING: ENSURE THAT THE DOWEL OF TOOL 204-114 IS CORRECTLY POSITIONED ACROSS THE SUSPENSION
TURRET SLOT.
Rotate stem of special tool 204-114 to correctly position dowel in suspension turret slot.
18. WARNING: WHEN TIGHTENING TOOL NUT, USE LOWER DOWEL AS A GUIDE TO ENSURE THAT THE TOOL STEM DOES
NOT ROTATE AND DISTURB POSITION OF DOWEL IN SUSPENSION TURRET.
Tighten nut of special tool 204-114 to full extent, to achieve suspension mid-laden position.
19. Raise front of vehicle and support on stands.
20. Remove front road wheels.
21. Remove crossbeam to engine Hydramount bolts.
-
Remove bolt securing crossbeam to Hydramount.
-
Fully withdraw bolt into crossbeam insert.
-
Repeat procedure to remove and withdraw bolt on opposite side.