XJ (X308) V8-4.0L SC (2003)
7. Measure brake disc run-out.
1. Install brake disc to hub and secure with all wheel nuts, tighten wheel nuts to 20 Nm in a diagonal sequence.
2. Position the gauge so that the pointer contacts the disc, between the disc's outer drill holes and the disc's outer edge.
^
Slowly rotate the disc one revolution, the disc run-out must not exceed the specification.
8. If the brake disc run-out exceeds specification, check the hub face run-out.
9. Remove brake discs.
10. Measure hub face run-out.
^
Position the gauge so that the pointer contacts the hub face.
^
Slowly rotate the hub one revolution, the hub run-out must not exceed the specification.
^
If the hub exceeds the maximum run-out specification replace the hub.
11. If the hub run-out is within specification replace brake discs.
12. Install caliper to hub carrier.
^
Install and tighten bolts to 60 Nm.