XJ (X308) V8-4.0L SC (2003)
/v8-4.0l_sc/Page-1114010.png)
19. Install suitable guide pins in spring pan/wishbone bolt locations.
20. WARNING:
WHEN ROTATING TOOL ADJUSTER, ENSURE THAT TOOL STEM DOES NOT TURN AND DISTURB POSITION OF DOWEL IN
SUSPENSION TURRET.
Install spring pan to wishbone securing bolts.
^
Rotate tool adjuster to gradually increase spring tension.
^
Progressively substitute spring pan securing bolts for guide pins.
^
Tighten spring pan bolts to 70-90 Nm.
^
Ensure spring lower seat is correctly positioned in spring pan.
21. WARNING:
WHEN ROTATING TOOL ADJUSTER, ENSURE THAT TOOL STEM DOES NOT TURN AND DISTURB POSITION OF DOWEL IN
SUSPENSION TURRET.
Remove Special Tool 204-111 from suspension.
^
Rotate adjuster of Special Tool to release tension on spring.
^
Rotate tool stem to release dowel from turret and withdraw tool assembly.
22. Lower vehicle to working height and support on stands.
23. Install wheel speed sensor.
^
Position wheel speed sensor on vertical link.
^
Install sensor securing bolt and tighten to 8-10 Nm.
24. Connect wheel speed sensor harness.
