XJ (X308) V8-4.0L SC (2003)
7. Install steering rack on crossbeam.
-
Ensure that bushes are correctly positioned on steering rack.
-
Position steering rack on crossbeam.
-
Position support brackets over bushes.
-
Install mounting bracket bolts and tighten to 40-54 Nm.
8. Install tie rods on steering arms.
-
Position and fully seat tie rod ball joint taper pin on steering arm.
-
Install tie rod ball joint nut and tighten to 71-85 Nm.
-
Repeat procedure to install opposite side tie rod ball joint.
9. Install harness on suspension turret.
-
Noting positions marked during removal, tape new securing clips to steering harness.
-
Install securing clips/harness on LH turret.
10. With assistance position crossbeam/suspension assembly on jack with protective wood under.
11. Traverse assembly into position below vehicle.
12. Ensure steering harness connector is positioned to avoid damage during crossbeam lift.
13. NOTE: It may be necessary to use a hammer and drift to finally align new mounting with body location.
Carefully raise crossbeam assembly into position.
-
Ensure that dowels of both crossbeam mountings are correctly seated in body locations.