XJ (X308) V8-4.0L SC (2003)
/v8-4.0l_sc/Page-1124003.png)
10. Tighten link to stabilizer bar securing nut to 60-80 Nm.
^
Repeat procedure at opposite end of stabilizer bar.
11. Install steering rack on crossbeam.
^
Ensure that bushes are correctly positioned on steering rack.
^
Position steering rack on crossbeam.
^
Position support brackets over bushes.
^
Install mounting bracket bolts and tighten to 41-54 Nm.
12. Install tie rods on steering arms.
^
Position and fully seat tie rod ball joint taper pin on steering arm.
^
Install tie rod ball joint nut and tighten to 71-85 Nm.
^
Repeat procedure to install opposite side tie rod ball joint.
13. Install steering harness on suspension turret.
^
Noting positions marked during removal, tape new securing clips to steering harness.
^
Install securing clips/harness on LH turret.
14. With assistance position crossbeam/suspension assembly on jack with protective wood under.
15. Traverse assembly into position below vehicle.
16. Ensure steering harness connector is positioned to avoid damage during crossbeam lift .
17. NOTE:
It may be necessary to use a hammer and drift to finally align new mounting with body location.
Carefully raise crossbeam assembly into position.
^
Ensure that dowels of both crossbeam mountings seat correctly in body locations.
