XJ (X308) V8-4.0L SC (2003)
/v8-4.0l_sc/Page-1173011.png)
11. Tighten new link arm to wishbone nut and bolt to 41 - 54 Nm.
12. Secure new link arm to stabilizer bar.
^
Tighten link arm to stabilizer bar nut to 60 - 80 Nm.
^
Check that ball joint freedom of movement has been maintained.
13. Install road wheel.
14. Repeat procedure steps 1 to 13 on opposite side of vehicle.
15. Raise front of vehicle, remove stands and lower vehicle.
16. Carry out steering geometry and wheel alignment checks and if necessary adjust.
Wheel Bearing
Wheel Bearing 60.25.40
Special Service tools
Hub Remover 204-193 (JD 224)
