XJ (X350) V8-4.2L (2005)
/v8-4.2l/Page-783002.png)
NOTE: Vehicles with 3.5L or 4.2L engine without supercharger shown, vehicles with supercharger similar.
2. Remove the FRP sensor.
-
Remove and discard the O-ring seals.
Installation
WARNING:
-
Do not smoke, carry lighted tobacco or an open flame of any type when working on or near any fuel related components. Highly
flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
-
Do not carry or operate cellular phones when working on or near any fuel related components. Highly flammable vapors are always
present and may ignite. Failure to follow these instructions may result in personal injury.
1. To install, reverse the removal procedure.
-
Install a new O-ring seals.
-
Tighten to 5 Nm.
