XJ (X350) V8-4.2L (2005)
Seat Belt Height Adjuster: Service and Repair
Front Safety Belt Shoulder Height Adjuster
Removal
1. Remove the B-pillar trim panel.
2. Detach the front safety belt upper mounting bracket.
3. Remove the front safety belt shoulder height adjuster.
Installation
CAUTION: Make sure all retaining bolts and retaining nuts are hand started and hand tightened prior to final tightening. Failure to follow this
instruction may result in component damage.
1. To install, reverse the removal procedure.
-
Tighten to 25 Nm.
2. Tighten to 35 Nm.