XJ (X350) V8-4.2L (2005)
16.
Clean the seal register and thoroughly inspect for damage.
INSTALLATION
Caution:
A soft faced hammer should be used to avoid damaging the special tool and creating debris.
Note:
Make sure the flat part of the seal is installed into the rack. Apply lubricant (Castrol WB or Petroleum Jelly), to assist seal installation.
17.
Lubricate and install the new steering gear pinion housing seal, using special tool 211-329-03 (Illustration 13).
18.
Align the steering rack to measurements shown in illustration 14.
19.
Remove the steering gear pinion housing from the plastic bag.