XJ (X351) V8-5.0L SC (2010)
/v8-5.0l_sc/Page-106002.png)
10. Remove the retaining bolts to the fender apron panel.
Installation
1. Offer up the hood hinge. Check alignment, if correct, proceed to next step, if not rectify and recheck before proceeding.
2. Tighten the hood hinge retaining bolts.
NOTE:
Bolts are pre-coated to inhibit galvanic corrosion and are reusable only if the coating is undamaged.
Tighten to 25 Nm.
3. The installation of associated panels and components is the reversal of removal procedure.
