XJR (X300) L6-4.0L SC (AJ16) (1995)
Front Door Latch: Service and Repair
LOCK MOTOR/LATCH ASSEMBLY, REMOVAL AND REPLACEMENT:
-
Remove door veneer panel. See Door Panel.
-
Remove door upper trim pad. See Door Panel.
-
Remove door lower trim pad. See: Front Door Panel
-
Using a suitable plastic knife, cut through the weather-shield to door sealant and reposition weather-shield for access.
-
Disconnect door handle link rod.
-
Disconnect door lock knob link rod.
-
Disconnect motor multi-plug.
-
Undo and remove door glass lower fixings.
-
Undo and remove motor securing bolts.
-
Displace and reposition the glass frame and the motor assembly.
Fig. 1
NOTE: Image shows front door components only.
-
Remove the motor assembly (Image).
-
Remove motor cover.
-
Remove the motor multi-plug inner housing.
-
Using special tool MS 1540 (JD 171), displace door ajar switch harness terminals from multi-plug and note position.
-
Displace and reposition door lock micro-switch.
-
Undo and remove lock motor securing screws.
Fig. 2
NOTE: Image shows front door components only.
-
Remove motor/micro-switch assembly and place lock aside (Image).
Refit in the reverse order of the removal procedure.